protecttore.blogg.se - 12v battery pulse charger manual

#12v battery pulse charger manual full

When the temperature is reduced to a normal level then the charger will enter charging mode automatically. The charger will enter overheat protection mode automatically when the internal temperature reaches the pre-set temperature limit, or if the charger is used in a high environment temperature for a long time. The charger will stop output automatically when the DC output clips short circuit. The charger will enter floating mode to prevent overcharging when the battery is fully charged.

To reduce the risk of battery explosion, please follow these instructions and those published by the car battery manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery.

Thus, it becomes the most important to use the charger according to the operation instructions.

Working near the acid battery is dangerous as the battery may release explosive gases during normal operation.

Only use Lithium mode for lithium iron phosphate batteries.

Please do not charge the car battery while your car engine is running.

Please choose the correct charging voltage according to the rated voltage of the battery or the battery will be damaged.

Please don’t close the hood, door or cover when using spring clips with the battery or it will cause a dangerously high current short circuit to the battery terminal.

AC power supply must comply with national electrical installation regulations.

Please keep the charger away from heat sources as they may damage the unit.

#12v battery pulse charger manual full

Please disconnect the AC plug when the battery is full and do not keep the charger unattended for a long time while charging.Please keep the area well ventilated when in use and do not cover the charger.Please do not put the unit on the battery when charging.Please do not charge a damaged or frozen battery.Please do not use the unit if there is a damaged power cord. Please check the power cord of the charger to make sure that it is not damaged before use.

Please do not expose the charger to rain or use it in a damp place to avoid danger.

The charger will warm up during use, this is normal and won’t affect its useful life.

Only authorised professionals may service this unit. Do not disassemble the charger yourself.The instructions and warnings should be read and understood before using and installing the battery charger.Hydride nedis solder metaalhydride nikkel soldeerlip zasmin Pin On Car Oooh Aaah And Stuff trickle desulfator batteryminder 15000mAH DC 5V/9V/12V USB High Capacity Rechargeable Li-ion Battery battery pack rechargeable ion 9v li dc 12v charger usb 5v capacity power conveniently charge Desktop Smart Battery Charger And Maintainer 12 Volt 1 & 4 Amp battery volt amp charger maintainer Untitled [battery charger charge 8 Amp LCD Intelligent Car Battery Charger Pulse Repair Starter 12V/24V starter hgv lorry trickle charging maintainer 8amp delivers Battery Charger .nzĬharger battery Ultrapower UP616 400w Battery Charger - Killa Drones ultrapower 400w 12V 6A Car Battery Charger Intelligent Fast Power Charging Pulse Repair caricabatterie starter maintainer lcd charging carica avviatore lidl accumulo piombo acido riparazione motorcycle mantenitori mantenitore caricatore caricabatteria intelligente batterie 12V 6A Full Automatic Car Battery Intelligent Fast Power Charging Pulse 5035232 Ansmann Rechargeable Battery Nickel Metal Hydride 1100 Mah 1.2 ansmann hydride USB Smart Battery Charger Fast Charge Rechargeable Li-on Battery ġ2v 6a full automatic car battery intelligent fast power charging pulse. Computer Controlled Battery Charger lygte-info.dkĬharger nimh rewire liion empty Nickel-Metal Hydride Battery | 1.2 V | 1100 MAh | Solder Connector | Nedis .uk 13 Pictures about Computer controlled battery charger : Pin on Car oooh aaah and stuff, Battery Charger and also Computer controlled battery charger.